Reference Tables 1. ISO STANDARDS AND PRACTICES. ISO 1829, ANSI B4.2, BS 4500 and AS 1654 are preferred tolerance standards. Hole Basis Shaft Basis Description Loose running fits are for wide commercial. ISO-Metric Tolerance Charts R–3. R–4 FOR INTERNAL MEASUREMENTS (HOLES)* µm +150 +100 +50 0 –50 –100 –150 from to.
I have some drawings from Germany that use the DIN 2768 tolerances and I am having trouble understanding it correctly. I do not have a full copy of the DIN but I do have some notes and a brief discription of how the tolerances are supposed to work but I still dont quite understand it.
The parts are shafts and couplings and have to fit bearings so I know some of the tolerances are going to be plus and some are minus. Could anyone offer a simpler explaination of what I am seeing. One of the external shafts has a f9 while most of the other shafts have a h9 or h6. A keyway has a N9 and the internal keyway has a j59. One of the internal bores has a M6.
Most of the tolerances use lower case but some are upper case, I dont know if that makes a difference or not. Anyone know of a source for a simpler explaination of these that is in english? Machtool, Yes I got that too, but there are a lot of other tolerances that are not listed in my handbook. I just need to find a better source and I am hoping to not have to buy all the standards if I dont have too. I am just quoting the job and I am still waiting on some answers from the company I got the drawings from. I thought I could get a head start and educate myself at the same time.
One shaft has a dim 25mm f9, a bore is marked M6 and to me that seems super tight, more than the part requires but I am hoping I just read the chart wrong. There are keyways and snap ring grooves and I just cant seem to find all the information I was hoping for in the MHB but I will keep searching. Charles, you have some weird tolerances on there, those are very rare for bearing fits. I have an ISO Tolerance book my company published, but it looks like it is not available any longer. 12mm h9 +0 / -43 25mm f9 -20 / -72 10mm h6 +0 / -9 Is the M6 hole tolerance also 25mm?
If so, it would be -4 / -17 By the way, DIN 2768mk is a general tolerance table that provides the tolerances for anything that is not toleranced on the drawing, it does not refer to the diameter tolerances you are asking about. You can find info on the DIN 2768 at the link below.
Thank you, I just found the tolerances on the keyway, and no the M6 is on a 47mm bore which makes me wonder why so tight a tolerance, I was hoping I was reading it wrong. I didnt see where you got the -17 from, at least that would allow me to have a little more room to work.
On the 12mm my MHB must have a typo because it says the tolerance is +43 -0? Nalogovaya sistema rk prezentaciya en. I didnt think that correct for a shaft but that is what is in my book.
Now you know why I wanted to ask others, this doesnt really add up. I really do need some reference that I can point to for these just in case there is any problem I need some printed version of these tolerances.